Search This Blog

Switching Regulator : Bootstrapping

A bootstrap circuit is needed when an Nch MOSFET is used for the high-side transistor of the output switch. Nowadays a number of power supply ICs comes with a bootstrap circuit mounted, and thus an understanding of the operation of the bootstrap circuit in connection with the evaluation of power supply circuits may be helpful.

Due to the low on-resistance, the Nch MOSFET can be used as a power switch to improve efficiency. Given the same on-resistance, the Nch MOSFET can be a lower cost option compared with the Pch MOSFET. That said, turning Nch MOSFET completely on as a high-side switch requires a high enough VGS, that is, a voltage higher than the drain voltage. Normally, because the drain voltage is Vin (input voltage), representing the highest voltage in the circuit, any higher voltage must be supplied externally. To generate that high voltage, a bootstrap circuit is used.

Simple in structure, a bootstrap circuit is a step-up charge pump composed of a switch, a capacitor, and a diode, where a voltage equal to the switch voltage (Vin) plus the internal supply voltage is used as the gate drive for the high-side Nch MOSFET.

A bootstrap-free Pch + Nch configuration

A bootstrap-free Pch + Nch configuration

A bootstrap-based Nch + Nch configuration

A bootstrap-based Nch + Nch configuration

  1. Nch MOSFET, low in on-resistance, helps to improve efficiency and provides a low-cost option.
  2. Use of the high-side transistor as an Nch MOSFET requires a VGS higher than the drain voltage.
  3. The voltage from an internal supply for an internal circuit may not be high enough to drive the Nch MOSFET.
  4. A step-up charge pump composed of a switch, a capacitor, and a diode generates the high voltage needed by the driver for the high-side Nch MOSFET. High-side gate driver power supply = Vin + Internal supply voltage - Diode VF

Lately, Nch MOSFETs have been mainly used for the output switching transistors in medium- or larger-power circuits, fueled by a trend that gives priority to efficiency at the expense of a modest increase in the number of components required. More recently, there has been an increase in the use of circuits incorporating external diodes as a way of cutting the number of required components.

Incidentally, for the same reasons as those mentioned above, bootstrap circuits are also used in nonsynchronous rectifying circuits. Beyond the Nch MOSFET, bootstrap circuits are also applied to reduce the saturation voltage in circuits that use bipolar NPN transistors.

Must Watch the below video from NPTEL - IIT

No comments

Popular Posts

Followers